Topics & Technologies

SIEMAG TECBERG's Own-developed, safe and reliable disk brake units

SIEMAG TECBERG disk brake units have been successfully used on numerous winders for many years. These units demonstrate a high performance capability covering a wide range of applications.

Our braking units can be used as a safety, driving and holding brake. They are constructed totally enclosed and can be used in the toughest operating conditions on winders, cableways, cranes and passenger and goods lifts. For the use on winders our own-developed brake elements, which are approved as components in compliance with the German Mining Regulations for Shaft and Inclined Conveying Equipment (BVOS), are fitted to system-adapted brake posts, in which the elements transmit the braking force to the brake disk or disks of the rope carrier. The braking force is applied under control to protect the hoisting equipment and on KOEPE hoisting systems to prevent rope slippage. Braking force is generated bypretensioned springs and opened hydraulically, so that in the event of fault the system can also be brought to a halt without the use of electrical power. Both wear on the brake linings and spring breakage are monitored and indicated.
 

Performance data of our brake callipers

    Brake unit pair

    BE 050

    BE 065  

    BE 100 

    BE 125

    Contact pressure [kN]

    2 x 50

    2 x 65

    2 x 100

    2 x 125

    Nominal air gap [mm]

    2-3

    2-3

    2-3

    2-3

    Brake unit pair

    BE 200

    BE 250

    BE 300  

    BE 350 

    Contact pressure [kN]

    2 x 200

    2 x 250

    2 x 300

    2 x 350

    Nominal air gap [mm]

    3-4

    3-4

    3-4

    3-4


    Technical features

    • High braking force
    • Unlimited service life – more than 2 million load changes during standard hoist runs
    • Low surface compression on the brake linings
    • Stepless, playfree fine adjustment
    • Fully enclosed against dirt and aggressive materials and substances
    • Monitoring of wear and spring breakage
    • Maintenance-friendly
    • Approved as BVOS-compliant component parts by the German Mining Authority
    More articles

    Further information

    For further information please contact us.

    Any questions?

    SIEMAG TECBERG GmbH

    Phone:+49 2773 9161-0
    Email:info@siemag-tecberg.com
    SEND EMAIL